BEST ACCESS SYSTEMS 35HW Manuel de service télécharger pdf (Page 86)

Service and Maintenance for Mortise Locks

4–32 W Series Service Manual

Task H. To remove the mortise case:

1. Remove the two case mounting screws.

2. Remove the case from the door.

Reinstalling

components for

electrified mortise

locks

The next three sections outline the tasks to perform in order to reinstall

components for electrified mortise locks with different types of trim.

Each section references the appropriate trim diagrams in Chapter 3 and

the detailed instructions for each task found in Tasks for reinstalling

the components.

Reinstalling the sectional trim and mortise case

Refer to the trim diagram on page 3–5 and the detailed instructions for

each task listed below.

1. Perform Task A. To reinstall the mortise case (page 4–33).

2. Perform Task B. To reinstall the mounting plates (page 4–35).

3. Perform Task D. To reinstall the roses (page 4–36).

4. Perform Task E. To reinstall the rose rings (page 4–36).

5. Perform Task F. To reinstall the cylinder (page 4–37).

6. Perform Task G. To reinstall the mortise case faceplate

(page 4–39).

7. Perform Task H. To reinstall the levers/knobs (page 4–39).

Figure 4.31 Removing the mortise case

Case mounting screws

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 227 228

Pas de commentaire

BEST ACCESS SYSTEMS 35HW Manuel de service Page 86