BEST ACCESS SYSTEMS 35HW Manuel de service télécharger pdf (Page 138)

Service and Maintenance for Cylindrical Locks

5–28 W Series Service Manual

For electrified locks

■ Install the rose.

■ Reinstall the inside lever/knob. See Task C. To reinstall the

lever/knob: on page 5–24.

Removing and

reinstalling the door

status switch and

magnet assembly

for IDH Max

Cylindrical Locks

Removing the door status and switch magnet assembly

1. Remove the inside lever/knob. See Task B1. To remove the keyed

lever/knob: on page 5–3.

2. Remove the access door. See Task C. To remove the access door: on

page 5–4.

3. Remove the upper and lower escutcheon screws from the inside

escutcheon.

Note: You can let the inside escutcheon dangle from the field wire

harness while completing this task.

4. Disconnect the door status switch connector from the sensor and

solenoid wire harness.

5. Remove the magnet from the hole in the door frame.

Reinstalling the door status and switch magnet assembly

1. Insert the new magnet in the hole in the door frame.

2. Insert the door status switch assembly into the door status switch

hole in the edge of the door, feeding the connectors out the wire

hole to the inside of the door.

Figure 5.33 Removing and reinstalling the door status switch and magnet

assembly

Magnet

Wire hole

Inside of door

Door status switch

Door jamb

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 227 228

Pas de commentaire

BEST ACCESS SYSTEMS 35HW Manuel de service Page 138