BEST ACCESS SYSTEMS 35HW Manuel de service télécharger pdf (Page 106)

Service and Maintenance for Mortise Locks

4–52 W Series Service Manual

4. For electrified locks, place the bridge rectifier in the same position

as the old one and glue it to the case using a gel-type adhesive that

bonds plastic and metal. Hold the bridge rectifier in position for one

minute to allow the adhesive to cure.

5. Make sure that the solenoid wires or cable is not pinched.

6. Clamp the solenoid wires or cable in the strain relief. Slide the strain

relief into position on the case. It should lock into place.

7. Reinstall the mortise case cover and case spacer. See Task H. To

reinstall the mortise case cover and case spacer: on page 4–48.

8. Reinstall the mortise case. See Reinstalling components for

IDH Max Mortise Locks on page 4–13 or Reinstalling components

for electrified mortise locks on page 4–32.

Replacing the RQE

switch

Removing the RQE switch

1. Remove the mortise case. See Removing components for IDH Max

Mortise Locks on page 4–3 or Removing components for electrified

mortise locks on page 4–26.

2. Remove the mortise case cover and spacer. See Task A. To remove

the mortise case cover and case spacer: on page 4–43.

3. Remove the wire strain relief from the case.

4. Open the wire strain relief and remove the RQE wires or cable.

5. Remove the hubs from the case. Maintain the orientation of the

hubs.

6. Tilt the RQE switch forward and remove it from the case.

Figure 4.51 RQE switch and hub orientation (closeup)

Pivot point on the RQE switch

Flat side of the outside hub

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 227 228

Pas de commentaire

BEST ACCESS SYSTEMS 35HW Manuel de service Page 106