BEST ACCESS SYSTEMS 35HW Manuel de service télécharger pdf (Page 107)

Service and Maintenance for Mortise Locks

W Series Service Manual 4–53

Reinstalling the RQE switch

1. Make sure that the new RQE switch components are oriented

correctly. When installed, the pivot point on the RQE switch should

be opposite the flat side of the outside hub, as shown in Figure 4.48.

Note: If you need to change the orientation of the RQE switch, see

step 3 through step 5, Task C. To turn over the RQE switch: on

page 4–44.

2. Tilt the RQE switch forward and slide it into place in the case.

3. Clamp the RQE wires or cable in the strain relief. Slide the strain

relief into position on the case. It should lock into place.

4. Reinstall the hubs. The flat side of the outside hub should be

opposite the pivot point on the RQE switch.

5. Reinstall the mortise case cover and case spacer. See Task H. To

reinstall the mortise case cover and case spacer: on page 4–48.

6. Reinstall the mortise case. See Task B. To reinstall the mortise case:

on page 4–14 or Reinstalling components for electrified mortise

locks on page 4–32.

Replacing the door

status switch

Removing the door status switch

1. Remove the mortise case. See Removing components for IDH Max

Mortise Locks on page 4–3 or Removing components for electrified

mortise locks on page 4–26.

2. Remove the mortise case cover and spacer. See Task A. To remove

the mortise case cover and case spacer: on page 4–43.

3. Remove the wire strain relief from the case.

4. Open the wire strain relief and remove the door status switch wires

or cable.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 227 228

Pas de commentaire

BEST ACCESS SYSTEMS 35HW Manuel de service Page 107