BEST ACCESS SYSTEMS 35HW Manuel de service télécharger pdf (Page 145)

Additional Service and Maintenance for IDH Max Locks

W Series Service Manual 6–5

7. Reinstall the core and throw member. For mortise instructions, see

Task H. To reinstall the core (EEL and EEU only): on page 4–23.

For cylindrical instructions, see Task I. To reinstall the core and

throw member: on page 5–17.

8. Making sure that the access door does not pinch any wires, insert

the tabs of the access door into its mating slots and swing the door

closed. Use the appropriate bit driver to secure the access door with

the security screw. Tighten firmly.

Removing and

reinstalling the field

wire harness

Removing the field wire harness

1. Remove the core and throw member. For mortise instructions, see

Task A. To remove the core: on page 4–3. For cylindrical

instructions, see Task A. To remove the core and throw member:

on page 5–3.

2. Remove the inside and outside knobs/levers. For mortise

instructions, see Task B. To remove the inside and outside

levers/knobs: on page 4–4. For cylindrical instructions,

see Task B1. To remove the keyed lever/knob: on page 5–3.

3. Use the appropriate bit driver to remove the security screw from the

access door. Open the access door and remove it from the inside

escutcheon.

4. Loosen the inside escutcheon and disconnect the connections. For

mortise instructions, see Task D. To disconnect the connections

and remove the outside escutcheon: on page 4–6. For cylindrical

instructions, see Task D. To disconnect the connections and

remove the outside escutcheon: on page 5–4.

5. For mortise locks, perform the following steps:

■ Remove the cylinder and mortise case faceplate. See Task E. To

remove the mortise case faceplate and cylinder: on page 4–10.

■ Remove the mounting plates. See Task F. To remove the

mounting plates: on page 4–11.

■ Remove the mortise case. See Task G. To remove the mortise

case: on page 4–11.

6. Remove the inside escutcheon from the door. For mortise

instructions, see Task H. To remove the inside escutcheon: on

page 4–12. For cylindrical instructions, see Task H. To remove the

inside escutcheon: on page 5–7.

7. Place the inside escutcheon on a flat surface.

8. Use a #1 Phillips head screwdriver to unscrew the lower-right

circuit board screw and remove the field wire harness strain relief.

Be careful not to touch the circuit board with the screwdriver and

not to strip the screw.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 227 228

Commentaires sur ces manuels

Pas de commentaire

BEST ACCESS SYSTEMS 35HW Manuel de service Page 145

Commentaires sur ces manuels

Produits connexes et manuels pour Contrôleurs de portes de sécurité BEST ACCESS SYSTEMS 35HW